top of page
Whitening Tray - Moldable

Whitening Tray - Moldable


Dip tray in heated water and mold to fit teeth. Comes with a top and bottom tray.


A) Heat a pan of water to 80-90C (not boiling, this will melt the trays!) 
B) Holding the handle, dip the mouth tray in the water for approximately 5-10 seconds. Be careful, as over-exposure will melt/shrink the tray, but under-exposure will make formation difficult. 
C) Remove the tray from the water and hold it to drain the excess water for a second. 
D) Place the tray in your mouth while it is soft and mould around your teeth, by pressing firmly on the inside and outside of your teeth with your fingers. Allow the tray to set firm while still inside your mouth. 
E) Remove the tray. Repeat this process for the lower tray. Cut the handles off and trim the formed trays, cutting at the gum line. This will allow you to clean any gel that may be leaking over the gums.


* This product cannot be returned due to health protection or hygienic reasons if unsealed by you after delivery

  • Returns and Exhanges

    Returns and Exchanges are not accepted due to sanitization reasons. 

bottom of page